ABB CEMcaptain GAA610-M Operating Instruction page 64

64 GAA610-M ADVANCED EMISSION GAS MONITORING SYSTEM | OI/GAA610-M-EN REV. B
... 12 Diagnosis / Troubleshooting
... Possible status messages
No. Text
Calibration (continuation)
508 Unknown error number. Check software versions.
509 Automatic calibration started.
510 Automatic calibration ended.
511 Automatic calibration interrupted externally.
512 Automatic calibration in progress.
513 System bus communication faulty during
automatic calibration.
514 External calibration started.
515 External calibration ended.
516 External calibration in progress
517 Device being serviced.
518 The calibration could not be performed, because
the measured value is not stable.
519 Preamplifier overflow error: Calibration could not
be performed because of preamplifier override.
520 Initial zero calibration started.
521 Initial zero calibration ended.
522 Initial zero calibration interrupted.
523 Initial zero calibration incomplete. System bus
communication fault during calibration.
524 Initial zero calibration started.
525 Linearization impossible: Linearization did not
produce a valid result. Measurement
526 Linearization impossible: Linearization could not
be performed, i.e. the characteristic is linear.
527 Initial calibration for component:
528 Autocalibration not started, i.e. manual
calibration was running.
529 Calibration was stopped because no raw
measured values were recorded.
530 Calibration stopped because the pressure switch
did not detect any calibration gas.
531 Automatic validation started.
532 Automatic validation ended.
533 Automatic validation externally interrupted.
534 Automatic validation in progress.
535 Automatic validation successful for:
536 Automatic validation out of limits for:
537 Automatic validation out of limits for:
S A W F Reaction/Remark
Message during the automatic calibration. Check analyzer module and system
controller software versions.
For information
For information
For information
x For information; not logged
For information
For information
x For information; not logged
x For information, e.g. during manual calibration, not logged
For information
For information
For information
For information
x For information; not logged
See message text
See message text
For information
For information
x x
x x
For information
For information
For information
x For information; not logged
x