Multi-Function Bay Devices - Fujitsu 565Tx User Manual

Floppy
Disk Drive
CD-ROM
Drive
Second
Lithium ion Battery
Figure 4-1 Multi-function Bay Modules

MULTI-FUNCTION BAY DEVICES

The bay on the right front panel of your note-
book accommodates the floppy disk drive, the
CD-ROM drive, an optional second Lithium
ion battery, or an optional second hard drive.
(See Figure 1-7 on page 5.)
U s e r I n s t a l l a b l e
C A U T I O N
All Multi-function bay devices except the
optional second Lithium ion battery must
be installed and removed with the power
switch in the Off position. The optional
second Lithium ion battery may be
warm swapped (power On but unit
in Suspend mode).
Second
Hard Drive
Release
F e a t u r e s
Finger Ridge
Figure 4-2 Removing a Module from
the Multi-function Bay
L i f e B o o k ™ 5 0 0 S e r i e s f r o m F u j i t s u
To Remove or Install a Module
in the Multi-function Bay
1. Close all files and exit all applications.
2. Turn off power to your notebook, close
the display and remove the AC adapter.
(See Power Off on pages 24 .)
To Remove
3. Slide the release latch on the right side
toward the bottom of your notebook.
4. Slide the module forward until it is clear
of the bay.
To Install
3.Orient the module to be installed with the
finger ridge away from the body of your
notebook and the connector toward the body
of your notebook.
4. With the module connector toward the back
of your notebook align the grooves on the
side of the module with the tracks in the side
of the bay. (Figure 4-2.)
5. Slide the module toward the back of your
notebook until it clicks into place.
™
95