Fujitsu 565Tx User Manual page 144

S e c t i o n F i v e
Problem
The display goes blank by itself after you have
been using it.
The Built-in Display does not close.
The Built-in Display has bright or dark spots.
20
Possible Cause
1. The notebook has gone into Idle mode,
Standby mode, Suspend mode or Save-to-
Disk mode because you have not used it for
a period of time.
2. Something is pushing on the Closed Cover
switch. (See Figure 1-7 on page 5.)
3. The power management timeouts may be
set for very short intervals and you failed to
notice the display come on and go off again.
1. A foreign object, such as a paper clip, is stuck
between the display and the keyboard.
1. If the spots are very tiny and few in number
this is normal for a large LCD display.
2. If the spots are numerous or large enough to
interfere with your operation.
Possible Solution
1. Use the keyboard or pointer and if that does
not restore operation,push the Suspend/
Resume button. You may want to close your
application and go to the setup utility Power
Savings menu and adjust the timeout values
to better suit your operation. (See the Power
Savings Menu on pages 83–88.)
2. Clear the Closed Cover switch.
3. Press any key or move the pointer, if this
doesn't work press the Suspend/Resume
button.
1. Remove all foreign objects from the
keyboard.
1. This is normal do nothing.
2. Display is faulty contact your support
representative.