Fujitsu 565Tx User Manual page 141

Problem
Shutdown and Startup Problems
The Suspend/Resume button does not work.
The system powers up, and displays power
on information, but fails to load the
operating system.
T r o u b l e s h o o t i n g
Possible Cause
1. The Suspend/Resume button is disabled from
the Power Savings menu of the setup utility.
2. You did not hold the button in long enough.
3. There may be a conflict with the application
software.
1. The boot sequence settings of the setup
utility are not compatible with your
configuration.
2. You have a secured system requiring a
password to load your operating system.
3. Hard Drive was not detected.
L i f e B o o k ™ 5 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
1. Enable the button from the Power Savings
menu of the setup utility. (See pages 83–88.)
2. Hold the button longer. This may need
to be a very long time if your application
is preventing the CPU from checking for
button pushes.
3. Close all applications,and try the
button again.
1. Enter the setup utility and adjust the Boot
Sequence settings from the Boot Options
submenu on pages 63–64.
2. Make sure you have the right password.
Enter the setup utility and verify the
Security settings and the Boot Sequence
settings and modify them as appropriate.
(See Security Menu on pages 79–83 and Boot
Options Submenu on pages 63–64.)
3. Use the BIOS setup utility Main menu,
Primary Master submenu to try to auto
detect the hard drive.
™
17