3 General Installation Guidelines
Tools and Materials
Safety and Preliminary Checks
TRU/FLO Compound Meter Installation and Maintenance Guide
This chapter describes tools, materials, and general installation information for the 3-inch,
4-inch, and 6-inch TRU/FLO meters.
Table 7 shows the recommended tools you need to successfully install or perform
maintenance on the TRU/FLO meter.
Table 7 is not a complete list of tools.
Part Number
N/A
9685-002, 003, 004, 005
11097-610, 600, 700, 800
9571-100, 110, 200, 300
9485-011, 006, 003, 008
9681-004, 001, 002, 003
N/A
Complete the following safety and preliminary checks before and during each installation:
•
Verify that you are at the location specified on the Site Work Order.
•
Verify that the site is safe for you and your equipment.
Table 7 Recommended Tools
Description
Contains standard tools including:
•
Flathead Screwdrivers
•
Hammer
•
Pliers
•
7/16-inch Wrench
•
Tool to Remove Snap Ring
Gasket Kit (size dependent).
Calibration Vane Assembly (size dependent).
Throttle Tube Assembly (size dependent).
Magnet Drive Assembly (size dependent).
Valve Assembly Kit (size dependent).
Flashlight.
7