Table of Contents
Advertisement
1 Lens
Attach an M42-mount lens or F-mount lens.
Caution
The maximum performance of the camera may not be realized depending on the lens.
Note
The following formula can be used to estimate the focal length.
focal length = WD/(1 + W/w)
WD: Working distance (distance between lens and object)
W: Width of object
w: Width of sensor 30.72 mm on this camera.
2 Direct connection
When mounting the camera directly to another device, for example, use screws that match the
camera locking screw holes on the camera. (M4, 6 mm depth)
Use the supplied screws to attach the tripod adapter plate.
Caution
For heavy lenses, be sure to support the lens itself. Do not use configurations in which its weight is supported
by the camera.
3 Camera Link cable
Connect the Camera Link cables to the DIGITAL I/O 1 and DIGITAL I/O 2 video output connectors.
• Use Cable Link compatible cables.
• Refer to the specifications of the cable for details on its bend radius.
For details on the cable, see "4
(page 8).
Caution
Secure the locking screws on the connector manually, and do not use a driver. Do not secure the screws too
tightly. Doing so may wear down the screw threads on the camera. (Tightening torque: 0.291 ± 0.049 N·m or
less)
Caution
When supplying power from the camera link cable,
If only DIDITAL I / O 1 is connected, it may not operate correctly when the operating load is high.
Supply power from both DIGITAL I / O 1 and DIGITAL I / O 2.
4 Frame grabber board
Refer to the operating instructions of the frame grabber board, and configure settings on the
computer as necessary.
5 Computer
Use a computer that meets the requirements of your frame grabber board.
6 DC IN / trigger IN connection cable
7 AC adapter (if necessary)
Connect the AC adapter and the round connector of the connection cable to the DC IN / trigger IN
connector on the camera.
DIGITAL I/O 1 and DIGITAL I/O 2 video output connectors"
— 13 —
SW-8000M-PMCL
Advertisement
Table of Contents
