Setting List - IAI SW-8000M-PMCL User Manual

Settings List
Control Tool
: Settings that can only be configured when image capture on the camera is stopped.
Item
a) Device Control
GenCP Version
Device Vendor Name
Device Model Name
Device Manufacturer Info
Device Version
Device ID
Device User ID
Device Scan Type
Device Temperature Selector
Device Temperature (Celsius)
Device Clock Selector
Device Clock Frequency
Device Serial Port BaudRate
Device Reset
b) Image Format Control
Pixel Format
Test Pattern
Binning Vertical
Binning Horizontal
Binning Horizontal Mode
c) Acquisition Control
Trigger Selector
Trigger Mode
Trigger Source
Trigger Activation
Trigger OverLap
Acquisition Line Rate
Exposure Mode
Exposure Time
d) Analog Control
1
*
Setting range depending on the Tap Geometry and CL Pixel Clock settings..
Setting range
— —
— "JAI Ltd., Japan"
— SW-8000M-
PMCL
— "See the
possibilities"
— —
— —
Any —
Linescan Linescan
Sensor Sensor, Sensor
Board Bottom,
Interface Board
Bottom, FPGA
— —
Camera Link Camera Link
84.82MHz, 42.41MHz
63.39MHz,
42.41MHz,
31.70MHz
Baud 9600, Baud 9600
Baud 19200,
Baud 38400,
Baud 57600,
Baud 115200
— —
Mono8 Mono8
Mono10
Off, Off
Monochrome,
GrayPattern,
White
1, 2 1
1, 2 1
Sum, Average Sum
Line Start Line Start
Off, On Off
CC1(Camera Link), —
Hirose 12Pin(TTL)
Rising Edge, Rising Edge
Falling Edge (rising edge of
input signal)
Off Off
*1
66 to 10272 10000
Off, Timed (control
Timed via exposure
time)
3 to 97 *1 97
— 33—
Default value
Display/configure information related to
the device.
Display the manufacturer name.
Display the model name.
Display the manufacturer information.
Display the device version.
Display the device ID.
Set the user ID for the camera.
Display the scan type of the camera.
Display the location of the temperature
sensor inside the camera.
Display the internal temperature (°C) of
the camera.
Select the camera clock.
Select the clock frequency for the
camera.
Select the baud rate for the camera's
serial board.
Reset the device.
Configure image format settings.
Set the pixel format.
Select the test image.
Set the number of pixels in the vertical
direction for which to perform binning.
Set the number of pixels in the Horizontal
direction for which to perform binning.
Set the addition process to be used during
horizontal Binning.
Configure image acquisition settings.
Select the trigger operation.
Select the trigger mode.
Select the trigger signal source.
Select the polarity of the trigger signal
(i.e., location of signal at which trigger is
applied).
Select the trigger overlap operation.
Set the line rate as a frequency. (unit: Hz)
Select the exposure mode.
Set the exposure time.
The maximum value when [Trigger Mode]
is set to [Off] varies depending on the
[Acquisition Line Rate Raw] value.
Configure analog control settings.
SW-8000M-PMCL
Description