Mld Snooping-Proxy Vlan Port Role Setting - ZyXEL Communications GS2220 Series User Manual

Table 103 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN
L ABEL
Robustness Variable
Last Member Query
Interval
Downstream
Query Interval
Maximum Response
Delay
Add
Cancel
Clear
Index
VID
Delete
Cancel
24.4.3 ML D Sno o ping - pro xy VL AN Po rt Ro le Se tting
Click the
Po rt Ro le Se tting
>
pro xy VL AN
on multicasting.
DESC RIPT IO N
Enter the number of queries. A multicast address entry (learned only on an upstream port
by snooping) is removed from the forwarding table when there is no response to the
configured number of queries sent by the router connected to the upstream port. This
value should be exactly the same as what's configured in the connected multicast
router.
This value is used to calculate the amount of time an MLD snooping membership entry
(learned only on the upstream port) can remain in the forwarding table.
Enter the amount of time (in miliseconds) between the MLD group-specific queries sent by
an upstream port when an MLD Done message is received. This value should be exactly
the same as what's configured in the connected multicast router.
This value is used to calculate the amount of time an MLD snooping membership entry
(learned only on the upstream port) can remain in the forwarding table after a Done
message is received.
When an MLD Done message is received, the Switch sets the entry's lifetime to be the
product of
L a st Me m b e r Q ue ry Inte rva l
Enter the amount of time (in miliseconds) between general query messages sent by the
downstream port.
Enter the maximum time (in miliseconds) that the Switch waits for a response to a general
query message sent by the downstream port.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to reset the fields to your previous configuration.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
This is the index number of the MLD snooping-proxy VLAN entry in the table. Click on an
index number to view more details or change the settings.
This field displays the ID number of the VLAN group.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Click to remove the selected entries permanently.
De le te
Click to clear the check boxes.
C a nc e l
link in the
Adva nc e d Applic a tio n
screen to display the screen as shown. See
GS2220 Series User's Guide
and
Ro b ustne ss Va ria b le
link on the top navigation panel to save
Sa ve
>
Multic a st
Section 24.1 on page 223
236
.
> >
IPv6 Multic a st ML D Sno o ping -
for more information