ZyXEL Communications GS2220 Series User Manual page 315

Advanced Application > VLAN Isolation
Fig ure 240
The following table describes the labels in this screen.
Table 157 Advanced Application > VLAN Isolation
L ABEL DESC RIPT IO N
Active Check this box to enable VLAN Isolation in a VLAN.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
VLAN ID Enter a VLAN ID from 1 to 4094. This is the VLAN to which this rule applies.
Promiscuous Ports Enter the number of the ports that can communicate with any ports in the same VLAN.
Other ports belonging to this VLAN will be added to the isolation list and can only send and
receive traffic from the ports you specify here.
Add Click
Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so
use the
memory when you are done configuring.
Cancel Click
Clear Click
Index This is the index number of the rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
VLAN This is the VLAN to which this rule is applied.
Promiscuous Ports This shows the ports that can communicate with any ports in the same VLAN.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove and then click the
Cancel Click
Chapter 34 VLAN Isolation
to insert the entry in the summary table below and save your changes to the
Add
link on the top navigation panel to save your changes to the non-volatile
Sa ve
to reset the fields to your previous configuration.
C a nc e l
to clear the fields to the factory defaults.
C le a r
to clear the check boxes.
C a nc e l
GS2220 Series User's Guide
315
button.
De le te