Lldp-Med Network Policy - ZyXEL Communications GS2220 Series User Manual

Table 169 Advanced Application > LLDP > LLDP-MED Configuration
L ABEL
MED TLV Setting
Location
Network Policy
Apply
Cancel
36.8 L L DP- MED Ne two rk Po lic y
Click
Adva nc e d Applic a tio n
shown next.
Advanced Application > LLDP > LLDP-MED Network Policy
Fig ure 255
The following table describes the labels in this screen.
Table 170 Advanced Application > LLDP > LLDP-MED Network Policy
L ABEL
Port
Application Type
Tag
VLAN
Chapter 36 Link Layer Discovery Protocol (LLDP)
DESC RIPT IO N
Select to enable transmitting LLDP-MED location TLV.
Select to enable transmitting LLDP-MED Network Policy TLV.
Click to save the changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
> >
L L DP L L DP- MED Ne two rk Po lic y (C lic k He re )
DESC RIPT IO N
Enter the port number to set up the LLDP-MED network policy.
Select the type of application used in the network policy.
• vo ic e
• vo ic e - sig na ling
• g ue st- vo ic e
• g ue st- vo ic e - sig na ling
• so ftpho ne - vo ic e
• vide o - c o nfe re nc ing
• stre a m ing - vide o
• vide o - sig na ling
Select to tag or untag in the network policy.
• tagged
• untagged
Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter "0".
GS2220 Series User's Guide
335
to display the screen as