Table of Contents
Advertisement
NH-2700
5.13.1.5 TERMINAL DHCP
If DHCP value is ENABLE, ATM uses DYNAMIC IP to connect to host. Otherwise, ATM uses STATIC
IP. If you configure DHCP value to DISABLE and press NEXT, it goes to TERMINAL IP SETUP
Screen.
NOTE: When you press NEXT button, if you configured DHCP to DISABLE, then it goes to Section No
5.13.1.6. If not, then it goes to Section No. 5.13.1.7.
5.13.1.6 TERMINAL IP
Set up STATIC IP using IP ADDRESS, SUBNET MASK, GATEWAY and DNS buttons.
It is able to input up to 15 units such as XXX.XXX.XXX.XXX
5- 132
5. Operator Function
Advertisement
Table of Contents
