Table of Contents
Advertisement
1.
BEFORE USING THE METER FOR THE FIRST TIME:
Turn over the meter, remove its' protective rubber sleeve and fit 4 "AA" batteries in
the battery compartment. Take great care to ensure they are fitted with the correct
battery polarity. Then replace the battery cover and protective rubber sleeve.
Always check that the meter is working correctly after replacing batteries.
Set the meter's correct time, date, fuel source, etc, after it is switched on and
calibrated – See USING THE ROTARY DIAL below. These are stored when the
meter is switched off.
Using Re-Chargeable Batteries.
This meter has been designed for use with both alkaline and rechargeable Nickel Metal
Hydride (NMiH). No other battery types are recommended.
WARNING
The battery charger unit must only be used when NMiH batteries are fitted.
Alkaline batteries are not re-chargeable. Attempting to recharge Alkaline batteries may result
in damage to the product and may create a fire risk.
Charging
Ensure that you use the correct charger. The part number is KMCU250/UK.
Ensure the batteries are fitted in the correct manner then on first charging, charge for at least
16 hours continuously, subsequently charge overnight.
NMiH batteries are entirely suitable for top up charging at any time, even for shorts periods.
An in-vehicle adapter can be used to top up the meter's batteries from a 12 volt vehicle
battery. The part number is KM12/12
Battery Disposal
Always dispose of depleted batteries using approved disposal methods that protect the
environment
2
KANE200 series manual
Advertisement
Table of Contents
