Before Using The Analyser For The First Time; Safety Warning; First Time Use; Normal Start Up Sequence - Kane 9206 Quintox User Manual

BEFORE USING THE ANALYSER FOR THE FIRST TIME.

SAFETY WARNING

This analyser extracts combustion gases that may be toxic in relatively low concentrations.
These gases are exhausted from the bottom of the instrument. This instrument must only
be used in well ventilated locations. It must only be used by trained and competent
persons after due consideration of all the potential hazards.

FIRST TIME USE

Charge the batteries for 12 hours, following this an overnight charge should be sufficient
for an average 8 hour day. There may be three battery packs that need charging, the main
battery, the optional heater battery and the handset battery. The handset battery can use
the same charger as the analyser unit or can be charged via the main unit using a handset
lead. All batteries are NiMh.
Whilst charging the red LED will flash.
We offer a wide choice of probes which are not supplied as standard and must be ordered
as a separate item.
Take time to read this manual fully.
TIP: Take a look at the Spare Parts list and order some replacement filters and
paper rolls now.

NORMAL START UP SEQUENCE

EVERY TIME YOU USE THE ANALYSER

BEFORE SWITCH-ON CHECK THAT:
 the oxygen sensor is connected
the particle filter is not dirty

 the sulphur filter is fitted for heavy oil or coal
the water trap and probe line are empty of water

all hose connections, etc, are properly made

33