Table of Contents
Advertisement
2.
BEFORE USING THE METER EVERY TIME:
Check the water trap is empty and the particle filter is not dirty:
-
To empty water trap, unplug its rubber stopper and re-plug once it is empty.
-
To change the filter, remove protective rubber sleeve, pull out the water trap
unit from the meter, remove the water trap's particle filter from its' spigot and
replace. Reconnect the water trap and rubber protective sleeve.
Connect the flue probe into the bottom of the meter's water trap and connect the
probe's temperature plug to the socket next to the water trap – check the plug's
orientation is correct otherwise incorrect temperature measurements will occur.
After switch on, check fuel source, date and time are correct and battery power is
sufficient.
SAFETY WARNING
This meter extracts combustion gases that may be toxic in relatively low
concentrations. These gases are exhausted from the back of the instrument. This
meter must only be used in well-ventilated locations by trained and competent
persons after due consideration of all the potential hazards.
3
KANE200 series manual
Advertisement
Table of Contents
