Before Using The Analyser For The First Time - Kane 450 User Manual

1. BEFORE USING THE ANALYSER FOR THE FIRST
TIME:
Turn over the analyser, remove its' protective rubber sleeve and fit 4 "AA" batteries in the
battery compartment. Take great care to ensure they are fitted with the correct battery
polarity. Then replace the battery cover and protective rubber sleeve. Always check that the
analyser is working correctly after replacing batteries.
Set the analyser's correct time, date, fuel source, etc, after it is switched on and calibrated –
See USING THE ROTARY DIAL below. These settings are stored when the analyser is
switched off.
Using Re-Chargeable Batteries.
This analyser has been designed for use with both alkaline and rechargeable Nickel Metal
Hydride (NMiH). No other battery types are recommended.
WARNING
The battery charger unit must only be used when NMiH batteries are fitted.
NMiH batteries are entirely suitable for top up charging at any time, even for shorts periods.
Alkaline batteries are not re-chargeable. Attempting to recharge Alkaline batteries may result
in damage to the product and may create a fire risk.
Ensure the batteries are fitted in the correct manner .
Charger
Ensure that you use the correct charger. The part number is KMCU450/UK.
An in-vehicle adapter can be used to top up the analyser's batteries from a 12 volt vehicle
battery. The part number is KMCU450/12
Trickle Charging
: on first charging, charge for at least 12 hours continuously,
subsequently charge overnight for approx. 8 hours.
Fast Charging
: With the analyser switched on connect the charger and then switch the
analyser off. The display will then show "BATTERY CHARGING"
Battery Disposal
Always dispose of depleted batteries using approved disposal methods that protect the
environment
KANE450 manual Page 4
Supplied By www.heating spares.co Tel. 0161 620 6677