Before Using The Meter For The First Time; Before Using The Meter Every Time; The Menu Functions - Kane KANE3500 Series Manual

1.

BEFORE USING THE METER FOR THE FIRST TIME:

Remove the cover and fit a new battery in the battery compartment. Take great
care to ensure that the battery is fitted with the correct battery polarity.
Replace the battery cover. Always check that the meter is working correctly after
replacing the battery.
Set the meter's correct date, time and pressure units. These are stored when the
meter is switched off.

2. BEFORE USING THE METER EVERY TIME:

After switch on check that date, time and pressure units are correct and that the
battery power is sufficient.
SAFETY WARNING
Never connect to a pressure source where you are not sure what the maximum
pressure might be. Always ensure that the meter you are using is correctly rated
for the pressure that you intend to measure. Excessive pressure (>5 times
nominal range) can permanently damage the meter's pressure sensor.
NOTE:
Use the '+' input for all single input measurements of pressure or vacuum. Only
use the '–' input when taking a differential measurement.
3.

THE MENU FUNCTIONS

The MENU structure comprises main menu options. STORE, SETUP and
PRESSURE have a sub-menu structure. SERVICE is for use by an approved
service organisation only.
Press and use the
MENU structure which is illustrated by the table on the following page, 'Using the
MENU'.
To exit the MENU function the final logical
made if the MENU function is aborted by pressing
, and buttons to navigate through the
is pressed. No changes are
.