Table of Contents
Advertisement
Appendix 1 - Main Parameters:
Here are the legends used and what they mean:
O
:
Oxygen reading in percentage (%)
2
O2R:
Oxygen reference setting. '----' means switched off or set to 0%.
T Flue:
Temperature measured by the flue gas probe in Centigrade or
Fahrenheit. It displays '- - -' if the flue probe is disconnected.
T Nett :
Nett temperature calculated by deducting the AMBIENT or INLET
temperature from the measured FLUE temperature. Displays in
either Fahrenheit (°F) or Centigrade (°C) or and will display '- - -' if
the flue probe is not connected.
CO:
Carbon Monoxide reading displayed in ppm (parts per million). '- -
-' is displayed if there is a fault with the CO sensor or the
instrument has not set to zero correctly, switch off instrument and
try again.
C0m:
Carbon Monoxide displayed in mg/m
COn:
Carbon Monoxide in ppm normalised to the O2R value
COĦ:
Carbon Monoxide in mg/m3 normalised to the O2R value.
COa
Carbon Monoxide calculation as if there were 0% Oxygen present.
This is only displayed in ppm
CO
:
Carbon Dioxide calculation determined by fuel type. This is only
2
displayed when a combustion test is being carried out. '- - -' is
displayed while in fresh air.
EFF :
Combustion efficiency calculation displayed in percentage either as
Gross (G) or Nett (N) or Condensing Nett (C) - Use MENU to
change. The calculation is determined by fuel type and uses the
calculation in British Standard BS845. The efficiency is displayed
during a combustion test, '- - - -' is displayed while in fresh air.
X - AIR :
Excess air calculated from the measured oxygen and type of fuel
used.
Displays reading during a combustion test. '- - - -' is displayed
while in fresh air.
Loss :
Losses calculated from Oxygen and type of fuel. Displays reading
during a combustion test. '- - - -' is displayed while in fresh air.
16
KANE200 series manual
3
.
Advertisement
Table of Contents
