Table of Contents
Advertisement
4.
USING THE ROTARY DIAL (starting from Menu):
Rotating the dial selects the display's 2
MENU
Rotate the dial to MENU and use the UP or DOWN buttons to
1
2
3
4
5
6
7
8
9
10 O
11 Gross or Net or Condensing Boiler / Furnace efficiency
12 ppm or mg/m
14 Service – Password protected for service personnel only
When you have selected the function to change, press ENTER to
select.
Repeat this to scroll through the menu and select (using the ENTER
key) and change (using the UP / DOWN keys) the function.
The final, logical ENTER returns you to the main menu display.
To exit the Menu function you can normally rotate the dial to
another position - Unless the final logical ENTER is pressed, no
changes are made.
6
nd
line, unless MENU is selected.
select the following function for change:
Time – Uses "Military" time as standard: 7am = 07:00,
7pm = 19:00
Date
The display's top line – select from the settings listed below
Temperature units -
The display's contrast
Boiler / Furnace fuel supply – select from fuels
Language
Header – 2 lines each of up to 16 characters that appear on the
printout. Use ENTER and UP/DOWN.
Store- save up to 16 sets of test results.
LOG saves a set of results when ENTER is pressed
DEL ALL clears all the memory when YES and ENTER
pressed. NOTE. ENTER must be pressed to exit this mode.
VIEW: the test number appears on the top line. The dial
position displays the stored values. Use UP or DOWN to
change test number. Use ENTER to exit this mode.
reference can be set between 0 and 20%
2
3
KANE200 series manual
o
o
F or
C
Advertisement
Table of Contents
