Using The Meter And Its Four Buttons - Kane KANE200 Manual

3.

USING THE METER AND ITS FOUR BUTTONS:

Switching ON Press
the Meter property about to be tested. This lets the meter auto calibrate its'
sensors properly.
On switch on, the meter beeps four times and displays on its' top
line the fuel previously selected, the date and time and model
number. Its' bottom line counts down from 60 until the sensors are
ready to use – This normally takes 20 - 30 seconds but may take
longer as sensors get older. If the meter will not auto calibrate, its'
sensors need to be replaced or recalibrated by an authorized repair
center.
If you connect the flue probe's temperature plug to the meter during
its' countdown the measured temperature will be used as the inlet
temperature.
If you do not connect the flue probe's temperature plug during
countdown the meter's ambient temperature will be used as the inlet
temperature.
When countdown is finished the display's top line shows the last
selected function and the bottom line displays whatever the rotary
dial is turned to.
Switching Press
OFF the Meter from 30 with the pump on to clean the sensors with fresh air – If the
probe is still connected, make sure meter and probe are in fresh air.
Press HOLD / ENTER if you want to stop the countdown and return
to making measurements.
Note: the meter will not switch off until the CO reading is below
20ppm
Using UP / Press for more than 1 second the DOWN button to change the
DOWN / display's top line. The Rotary Dial changes the display's bottom
ENTER line.
Buttons
For example, the meter will display CO
Efficiency on its' bottom line if you turn the rotary dial to EFF and
push the DOWN button until CO
Use the UP / DOWN / ENTER keys to change settings (such as
time, date and fuel) when the rotary dial is turned to MENU.
4
button to switch the unit ON in fresh air outside the
button to switch the meter OFF. The display counts down
KANE200 series manual
on its' top line and
2
is displayed on the top line.
2