Replacing The Water-Separator Filter; Draining And Cleaning The Fuel Tank; Cleaning The Fuel-Intake Screen - Toro Reelmaster 7000-D Operator's Manual

Replacing the Water-Separator Filter

1. Fully drain the fuel-water separator.
2. Clean the filter head
3. Remove the filter canister, and clean the
mounting surface of the filter head.
4. Lubricate the gasket on the filter canister with
clean fuel.
5. Install the filter canister by hand until the
gasket contacts the mounting surface, then
rotate it an additional 1/2 turn.
6. Tighten the drain valve at the bottom of the
filter canister.
7. Start the engine and check for leaks.
Note:
8. Shut off the engine and remove the key.
9. Close and latch the hood.

Draining and Cleaning the Fuel Tank

Drain and clean the fuel tank if the fuel system becomes contaminated or if the machine is to
be stored for an extended period. Use clean fuel to flush out the tank.
1. Prepare the machine for maintenance.
2. Align a drain container under the drain valve
at the bottom of the fuel tank.
3. Open the drain valve and allow the fuel to
drain.
4. If needed, add clean fuel to the fuel tank to
flush it out.
5. Close the drain valve.
Note:
the drain valve for leaks.

Cleaning the Fuel-Intake Screen

The fuel-intake tube, located inside the fuel tank, is equipped with a screen to help prevent
debris from entering the fuel system. Remove the fuel-intake tube and clean the screen as
required.
1. Prepare the machine for maintenance.
2. Tilt the seat.
Maintenance: Fuel System Maintenance
and filter canister
Repair all leaks.
When you add fuel to the tank, check
.
G425089
G425122
Page 6–20 3466-706 A