Pci Control - AOpen AP5C User Manual

AMI BIOS
16-bit I/O Recovery Time
This parameter allows you to set the response time of the 16-bit I/O
connected to your system. The range is from 1~4 SYSCLK. The
default setting is 1 SYSCLK.

PCI Control

VGA Palette Snooping
PCI devices support the "palette snooping" technique that enables
the device to control access to their palette registers.
Set this parameter to to activate the palette snooping
Enabled
function in the PCI VGA devices installed in your system.
PCI-IDE Card Selection
This parameter allows you to select the PCI-IDE card that you want to
enable. The board can support a maximum of four PCI-IDE cards.
The available selections are Slot 1, Slot 2, Slot 3, Slot 4, and Absent.
Select Absent if you do not have any PCI card installed.
PCI Primary IDE INT# Line
This parameter lets you assign an INT for the IDE device connected
to your primary IDE connector. The settings are INT A, INT B, INT C,
INT D, Absent and Not Used. If you do not have any PCI IDE card
installed in your system and your PCI IDE Card Selection parameter
setting is Absent , this parameter becomes non-configurable.
3-20 User's Guide