AMI BIOS
Hit "Del" Message Display
This option lets you enable or disable the Hit <Del> if you want Setup
message from appearing when the system boots. The default setting
is
Enabled
.
Extended BIOS RAM Area
This function allows you to relocate the BIOS from ROM to RAM.
Relocating to RAM enhances system performance as information
access is faster than ROM. The parameter settings are 0:300 and
DOS 1K. The default address is
Wait for F1 If Any Error
If this option is enabled, the BIOS waits for the end user to press
before continuing. If this option is disabled, the BIOS continues the
boot process without waiting for
is
Enabled
.
System Boot-up Num Lock
Setting this parameter to
numeric keypad. Set this parameter to
Disabling the numeric function allows you to use the numeric keypad
for cursor control. The default setting is
Floppy Drive Seek at Boot
When enabled, the BIOS detects whether there is a floppy disk drive
installed. Disable the parameter to bypass the function. The default
setting is
Disabled.
3-8
0:300
.
l
to be pressed. The default setting
enables the numeric function of the
On
Off
to disregard the function.
On
.
l
User's Guide
Need help?
Do you have a question about the AP5C and is the answer not in the manual?