Global Dhcp Relay Configuration Example - ZyXEL Communications XS1930 Series User Manual

The following table describes the labels in this screen.
Table 139 IP Application > DHCP > DHCPv4 > Global > Port
LABEL
Port
Option 82 Profile
Add
Cancel
Clear
Index
Port
Profile Name
Delete
Cancel

33.4.5 Global DHCP Relay Configuration Example

The follow figure shows a network example where the Switch is used to relay DHCP requests for the
VLAN1 and VLAN2 domains. There is only one DHCP server that services the DHCP clients in both
domains.
Chapter 33 DHCP
DESCRIPTION
Enter the number of port(s) to which you want to apply the specified DHCP option 82 profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For example,
enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Select a pre-defined DHCP option 82 profile that the Switch applies to the specified port(s). The
Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to
DHCP requests that it relays to a DHCP server.
The profile you select here has priority over the one you select in the DHCP > DHCPv4 > Global
screen.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Click Clear to reset the fields to the factory defaults.
This field displays a sequential number for each entry. Click an index number to change the
settings.
This field displays the port(s) to which the Switch applies the settings.
This field displays the DHCP option 82 profile that the Switch applies to the port(s).
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select the entry(ies) that you want to remove, then click the Delete button to remove the
selected entry(ies) from the table.
Click this to clear the check boxes above.
XS1930 Series User's Guide
268