ZyXEL Communications XS1930 Series User Manual page 36

Table 5 LED Descriptions (continued)
LED COLOR
SYS Green
Red
CLOUD Green
Amber
LOCATOR Blue
PoE MAX Green
(XS1930-12HP) (Bar1-Bar3)
Bar1 is the bar at
the bottom; bar
5 is the bar at
the top.
Yellow
(Bar4)
Red
(Bar5)
10GBase-T Ports
LNK/ACT Blue
1-8 (XS1930-10)
Purple
9-10 (XS1930-
12HP)
Sky Blue
Green
Amber
PoE 10GBase-T Ports
Chapter 3 Hardware Panels
STATUS DESCRIPTION
On The Switch is on and functioning properly.
Blinking The Switch is rebooting and performing self-diagnostic tests.
On The Switch is functioning abnormally.
Off The power is off or the Switch is not ready/malfunctioning.
On The Switch is managed by the NCC (Nebula Control Center).
Blinking The Switch is connected to the NCC, but not registered.
On The Switch is in Nebula cloud management mode. It was trying to connect to
the NCC, but failed.
Blinking The Switch is in standalone mode. It was trying to connect to the NCC, but
failed.
Off Nebula cloud management mode is disabled.
On The Switch is uploading firmware. While the Switch is doing this, don't turn off
the power.
Blinking Shows the actual location of the Switch between several devices in a rack.
The default timer is 30 minutes when you are configuring the Switch.
Off The locator is not functioning or malfunctioning.
On Each bar represents 20% of PoE Power consumption.
Bar 1: PoE power usage is below 20 percent of the power supplied budget.
Bar 2: PoE power usage is below 40 percent of the power supplied budget,
but over 20 percent of the power supplied budget.
Bar 3: PoE power usage is below 60 percent of the power supplied budget,
but over 40 percent of the power supplied budget.
On PoE power usage is below 80 percent of the power supplied budget, but
over 60 percent of the power supplied budget.
On PoE power usage is more than 80 percent of the power supplied budget.
Blinking Less than 5 percent of the power supplied budget remains. 5 percent is the
default value.
Off PoE power usage is 0 percent of the power supplied budget.
On The link to a 10 Gbps Ethernet network is up.
Blinking The Switch is transmitting/receiving to/from a 10 Gbps Ethernet network.
On The link to a 5 Gbps Ethernet network is up.
Blinking The Switch is transmitting/receiving to/from a 5 Gbps Ethernet network.
On The link to a 2.5 Gbps Ethernet network is up.
Blinking The Switch is transmitting/receiving to/from a 2.5 Gbps Ethernet network.
On The link to a 1000 Mbps Ethernet network is up.
Blinking The Switch is transmitting/receiving to/from a 1000 Mbps Ethernet network.
On The link to a 100 Mbps Ethernet network is up.
Blinking The Switch is transmitting/receiving to/from a 100 Mbps Ethernet network.
Off The link to an Ethernet network is down.
XS1930 Series User's Guide
36