GASLAND chef Pro Series Installation Instructions Manual page 35

• Residue on the front frame of the oven and
outside the gasket on the door will need to
be cleaned by hand. Clean these ares with
hot water, soap-dilled steel-wool pads, or
cleansers such as Soft Scrub. Rinse well
with clean water and dry.
• Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for the
gasket to remain intact. If you notice it
becoming worn or frayed, have it replaced. (Fig.18)
• Make sure the oven light cover is in place and the oven light is off.
NOTE
Remove oven racks and accessories before starting the Self-clean mode.
How to run a Self-clean cycle
01. Select the length of time for the Self-clean operation, eg. 3 hours. Touch
Self Clean 2/3/5h once for a 3 hour clean time, twice for a 5 hour clean time,
or 3 times for a 2 hour clean time the default setting is 3 hours.
02. Touch START to start the Self-clean cycle. The motor-driven door lock will
engage automatically.
NOTE
• You will not be able to start a Self-clean cycle if the Control Lockout feature is
activated or if the oven's temperature is too hot.
• The oven door locks automatically. The display will show the cleaning time
remaining. You cannot open the oven door until the temperature drops to a
safe/cool temperature.
03. When the Self-clean cycle is done, End will appear in the display and the
oven will beep 6 times.
How to delay the start of Self-clean
01. Touch Self-clean 2/3/5h.
Select the desired Self-clean time by touching Self-clean 2/3/5h.
02. Touch Delay Start.
03. Enter the time you want the Self-clean cycle to start.
04. Touch START.
The display will show Delay, Self-clean, and the Lock icon. The motordriven
door lock will engage automatically.
05. The Self-clean cycle will turn on automatically at the set time.
1 (844) 538-7890
support@gaslandchef.com
Fig.18
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
34
Don't hand
clean the oven
door gasket.
You may
hand clean
the door