Prepare Built-In Oven; Remove And Replace Oven Door - GASLAND chef Pro Series Installation Instructions Manual

13

Prepare built-in oven

WARNING
Excessive Weight Hazard
Use two or more people to move and install an oven.
Failure to do so can result in back or other injury.
01. Decide on the final location for the oven. Avoid drilling or cutting into house
wiring during installation.
02. To avoid floor damage, set the oven on a cardboard prior to installation. Do
not use handle or any portion of the front frame for lifting.
03. Remove the shipping materials and tape from the oven. Remember to keep
the packing materials that may be needed for installation.
04. Remove the hardware package from inside of the bag containing literature.
05. Remove racks and other parts from inside the oven.
06. Move oven and cardboard close to the oven's final location.

Remove and replace oven door

IMPORTANT: Use two hands to remove oven door.
Prior to removing the oven door, prepare a surface where you will place it. This
surface should be flat and covered with a soft blanket, or use the corner posts
from your packaging material.
Remove oven door
01. Open the oven door.
02. Locate the oven door hinge lock in both
corners of the oven door, and then rotate the
hinge locks toward the oven door to the
unlocked position (see Fig.1). If the door hinge
lock is not rotated fully, the door will not remove
properly.
03. Partially close the door to engage the door latch
locks.
The door will stop at this point.
1 (844) 538-7890
support@gaslandchef.com
Fig.1
A. Oven door hinge lock
in locked position
B. Oven door hinge lock in
unlocked position
Fig.2
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418