Toro Power TRX Commercial 1428 Service Manual page 63

Shift Rod Adjustment (continued)
Auger Control
POWER TRX™ HD Service Manual
3440-740 Rev A
Note: The adjustment point is a trunnion on the upper end of the shift rod.
g263053
2. Pull the shift rod and arm upward as far as they will go. With the shift lever in
R2, adjust the trunnion to take the slack out and re-secure.
Note: Excessive slack in the linkage may cause the drive to be in reverse
when shifted into first gear.
g263054
The bail on the RH handle is the auger control. Squeeze the bail and the cable
causes an idler to pivot the tensioning in the auger belt.
Figure 53
Figure 54
Page 6–15 Controls: Service and Repairs