Toro Power TRX Commercial 1428 Service Manual page 57

QUICK STICK® Disassembly (continued)
QUICK STICK®Reassembly
POWER TRX™ HD Service Manual
3440-740 Rev A
g262320
1. Place the latch spring over the boss. The straight end of the spring should be
down with the hooked end facing up.
g262321
2. Slide the latch trigger over the boss until it is fully seated, making sure that
the stop on the trigger lever is above the stop on the quick lever. While
holding the trigger lever in place, rotate the hooked end of the spring until
it hooks under the front edge of the trigger lever.
3. Rotate the cable until the barrel fitting slides onto the cable lever.
4. Install the latch trigger and spring. Lift the metal latch pawl onto the cable
lever hex.
5. Install the top handle into position, secure with 5 Phillips head screws.
6. Install the (1 3/4 inch) friction washer. Slide the chute control rod into place.
Secure with a (9/16 inch) locknut onto the shoulder bolt.
7. Install both globes. Secure with 2 Phillips head screws on the right hand side
of the chute control cover (the part that looks like a ball).
8. Install the cap and screw retaining the blue lever cap.
Figure 43
Figure 44
Page 6–9 Controls: Service and Repairs