Toro Power TRX Commercial 1428 Service Manual page 42

Hydro Removal (continued)
Hydro Installation
Track Drive System: Service and Repairs
g332818
18. Using a floor jack, slowly lower and remove the hydro from the machine.
1. Using a floor jack, slowly raise the hydro and lower frame brace into the
housing.
2. Install the 2 (1/4–20 x 2 1/4 inch) screws and 2 (5/16–18 x 3/4 inch) nuts
securing the LH lower frame brace to the LH traction frame. Repeat on the
RH side of the machine
g332816
3. Install the 2 (1/4–20 x 2 1/4 inch) screws and 2 (5/16–18 x 3/4 inch) nuts
securing the LH hydro to the LH traction frame. Repeat on the RH side of
the machine.
Figure 22
Figure 23
Page 5–12 POWER TRX™ HD Service Manual
3440-740 Rev A