Toro Power TRX Commercial 1428 Service Manual page 37

Hydro Removal (continued)
POWER TRX™ HD Service Manual
3440-740 Rev A
3. Remove the tracks from the machine.
4. Remove the 3 (1/4–20 x 5/8 inch) screws securing height adjust assembly
and pivot bar to the frame.
g332811
5. Remove the LH clutch cable from the LH clutch cable lever. Repeat on the
RH side of the machine.
g332812
6. Remove the (1/4–20 x 5/8 inch) screw securing the traction cable to the
underside of the control panel. Remove the traction cable.
7. Remove the 4 (1/4–20 x 5/8 inch) bolts securing the rear cover to the traction
frame and bottom cover. Remove the rear cover.
8. Unclip the clutch cables from the rear cover.
Track Removal (page 5–5)
Figure 12
Figure 13
Page 5–7 Track Drive System: Service and Repairs