Pressure - TESTO 320 Instruction Manual

6.2.9.
info@Testo-Direct.com
All manuals and user guides at all-guides.com
Determine smoke tester no./smoke nos./oil depos. with the
smoke tester testo 308 and transmit wirelessly:
- The testo 308 must be in data transfer mode (
> [Options] → t308.
- The values recorded by the smoke tester are transferred to the
testo 320.
Entering the heat carrier temperature:
>
Heat carrier. [Edit]
→
Options:
> [Options] → Clipboard: data is saved to the clipboard.
> [Options] → Delete
is deleted.
> [Options] → Save: the measured values are saved in a record.
> [Options] → Reset

Pressure

✓ The gas pressure set (0554 1203) must be connected.
Call up function:
[ ] Measurement options
> →
Carrying out the measurement:
WARNING
Dangerous mixture of gases
Danger of explosion!
> Make sure there are no leaks between the sampling point and
the measuring instrument.
> Do not smoke or use naked flames during measurement.
Do not measure for longer than 5 min, as the drift of the
pressure sensor could mean that the measured values are
outside the tolerance limits.
1. Connect the gas pressure set to the probe socket.
2. Start measurement:
- Pressure zeroing is carried out (system must be unpressurised).
3. Pressurise the system.
- The measured value is displayed
4. End measurement:
www.
→ enter value → [OK].
clipboard: any data saved to the clipboard
values: The entered values are deleted.
[OK]
→ →
[ ].
[ ].
Testo-Direct
6 Using the product
lights up).
Pressure → [OK].
51
1.888.610.7664
.com