Table of Contents
Advertisement
Use only the recommended manufacturer accessory .Using the
accessory other than in relevant chapter may cause to increase the
Measurements can be affected by mobile and RF communications
equipment. It should be assured that the Electrocardiograph is used
should not be used adjacent to or stacked with other equipment
Do not use cellular phone in the vicinity of this equipment. High
result in strong level of electromagnetic radiation emitted from such
devices may interference with the Electrocardiograph performance.
Guidance and manufacturer's declaration – electromagnetic emissions
The Dena Electrocardiograph is intended for use in the electromagnetic environment specified
below. The customer or the user of the Dena should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
APPENDIX IV
EMISSION or decrease the IMMUNITY of system.
in the electromagnetic environment specified
To prevent EMC effect on the Electrocardiograph, the system
and that if adjacent or stacked use is necessary, the equipment
should be observed to verify normal operation in the
configuration in which it will be used.
Compliance
Group 1
Class B
Complies
Complies
EMC
Electromagnetic environment - guidance
The Dena uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby
electronic equipment.
The Dena is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
8
Advertisement
Table of Contents
