Record - Avtech 36CH XVR Series User Manual

Select REGION 1 or REGION 2, and choose EDIT to change the setting.

ENABLE
QUALITY
AREA
 Camera Guard
This function is used to lock the camera to a fixed point and no pan action could be made until the lock mode is
disabled. Before using this function, make sure:
1. You've configured at least one preset point and one preset group for the connected camera. To know how to
configure preset points and preset group, please refer to "5.5 PTZ Control" at page 17.
2. You have an iOS or android mobile device with our free app, EagleEyes, installed.
3. Your recorder is connected to Internet, and registered in the address book of EagleEyes.
GUARD LOCK
TIMEOUT (SECS)
PRESET GROUP
PRESET NUMBER
Item
GUARD LOCK
TIMEOUT (SECS)
PRESET GROUP
PRESET NUMBER

6.2 RECORD

Set the image size, video quality and other related parameters individually for live display, record streaming and
sub streaming.
Note: The settings shown below depend on the setting tab you selected in this setting page.
a) D.O.R (Depend on record): When this option is checked, the video size, quality and other related
parameters will follow the configurations in RECORD STREAM.
b) PROFILE: Select the video profile pre-defined in your IP cameras. You can directly use the profile setting,
or modify the setting on this page.
c) TYPE: Select the compression format for each channel.
Note: The options selectable for TYPE depend on the camera you're intended to connect.
d) IMAGE SIZE: Select the image size for each channel.
Note: The options selectable for IMAGE SIZE depend on the camera you're intended to connect.
e) QUALITY: Select the video quality for each channel. The higher the value, the better the image quality.
f) I.P.S.: Image per Second, the higher the value, the more fluent the video.
Note: The options selectable for "I.P.S." depends on the camera you're intended to connect.
g) BITRATE (kbps): Select how much data to process per unit of time for each channel. The higher the
value, the better the video quality.
REGION OF INTEREST – EDIT
APPLY
CAMERA GUARD – CH1
Description
Enable (ON) or disable (OFF) this function.
Configure the timeout in seconds (30 / 60 / 90 / 120) after which the camera will be fixed to the
current point and any attempt to pan the camera to another point will be failed.
Choose the group where the point you'd like to use is configured, and go to PRESET NUMBER
to choose the preset point number.
Choose the preset point number you'd like to use when GUARD LOCK is enabled.
ON
SETUP
ON
30
1
1
APPLY
MAIN MENU
24