Appendix 2 Push Video Configuration; A2.1 Alarm Sensor Connection - Avtech 36CH XVR Series User Manual

APPENDIX 2 PUSH VIDEO CONFIGURATION

Note: This function is for selected models only.

A2.1 Alarm Sensor Connection

Connect the alarm sensor, such as magnetic contacts, to the alarm-in port on the rear panel. Alarm-in 1
corresponds to video channel 1, alarm-in 2 corresponds to video channel 2, and so on.
Note: The voltage restriction for alarm-in device connection is under DC24V 1A.
If the connected camera is our brand's camera with alarm I/O support, you can simply connect the alarm sensor
to the camera, and the alarm function will go with the camera.
Note: Please check the user manual of the camera to know voltage restriction for alarm-in device
connection.
Then, go to MENU  CAMERA  DETECTION and make sure:
1. MOTION is set to ON.
2. ALARM is configured (N.C. / N.O.) when an external alarm device is connected, or
INTERNAL ALARM is set to ON when the connected camera has a PIR sensor built-in.
CHANNEL TITLE
CH1 OFF
N.C.
CH2
N.O.
CH3
OFF
CH4
ALARM INTERNAL ALARM
ON
OFF
OFF
OFF
DETECTION
SENSITIVITY MOTION
EDIT ON
EDIT ON
EDIT OFF
EDIT OFF
APPENDIX 2 PUSH VIDEO CONFIGURATION
AREA ADVANCED CONFIG
EDIT
EDIT
EDIT
EDIT
APPLY
55