Maintain; System - Avtech 36CH XVR Series User Manual

3) PROTOCOL
Select NORMAL (our protocol), P-D (PELCO-D), P-P (PELCO-P), S-T (SAMSUNG-T) or
S-E (SAMSUNG-E) protocol.
4) DEVICE
Select the baud rate for the connected speed dome camera (2400 / 4800 / 9600 / 19200 / 38400 /
57600 / 115200).
Make sure the baud rate setting of the camera is the same as the setting here, or the recorder will not be able
to control the device.
Note: To know the default baud rate of the speed dome camera, please refer to its user manual.
5) INTERFACE
Select RS485 if the connected speed dome camera uses RS485 wires to transmit control signals.

6.12 MAINTAIN

6.12.1 SYSTEM

BACKUP CONFIG
RESTORE CONFIG
RESET DEFAULT
DEVICE TITLE
ENABLE AUTO PLUG AND PLAY
BIND MAC ADDRESS
1) BACKUP CONFIG / RESTORE CONFIG
To save the DVR current configurations for later use, such as restoring after DVR upgrade or applying to
another DVR, insert a compatible USB flash drive into the USB port, and select SUBMIT in SUBMIT in
BACKUP CONFIG to copy the current DVR configurations to a file "System.bin" and save to your USB
flash drive.
To restore the DVR configurations, insert the USB flash drive including "System.bin" to the USB port, and
select SUBMIT in RESTORE CONFIG.
2) RESET DEFAULT
Click SUBMIT to reset all settings or partial settings to their factory default values, and select YES to
confirm or NO to cancel. The system will reboot after reset.
3) DEVICE TITLE
Enter a title for this device.
4) ENABLE AUTO PLUG AND PLAY
Switch to ON to allow the camera to be detected and configured automatically when it's connected to this
device.
Note: This function is available only when the brand of the cameras connected is the same as this
device.
5) BIND MAC ADDRESS
This function is recommended to be used when your surveillance system is more than 256 cameras. It would
be helpful for the system to get the address of each connected camera quickly if the system accidentally
shuts down and needs to recover.
SYSTEM
SUBMIT
SUBMIT
SUBMIT
dvr_1
ON
OFF
MAIN MENU
46