Daylight; Display - Avtech 36CH XVR Series User Manual

Note: You may receive NTP-based DDoS attacks when this function is enabled. Please make sure your
network is secured to prevent this kind of attack.

6.9.2 DAYLIGHT

DAYLIGHT SAVING
START TIME
END TIME
ADJUST
Depending on the time zone you're in:
1) DAYLIGHT SAVING
Select to enable (ON) or disable (OFF) this function.
2) START TIME / END TIME
Set the start time and end time.
3) ADJUST
Set the time in HOUR : MIN.

6.10 DISPLAY

CHANNEL TITLE
EVENT STATUS
AUTO KEY LOCK(S)
HDD DISPLAY MODE
DISPLAY OUTPUT
LANGUAGE
HDMI2 DISPLAY
SPOT MONITOR
1) CHANNEL TITLE
Select to display the channel title or not (ON / OFF).
2) EVENT STATUS
Select to display the event icons or not (ON / OFF).
Note: For details about each event icon, please refer to "4.3 Status & Operation" at page 11.
3) AUTO KEY LOCK(S)
Set the time-out in second after which the key lock function is activated (NEVER / 30 / 60 / 120).
4) HDD DISPLAY MODE
Select REMAINING SIZE to show the remaining HDD capacity for recording in GB, or REMAINING
TIME to show the remaining recording time.
5) DISPLAY OUTPUT
Select the display resolution you want. The default value is AUTO. This is used for the main display output.
Note: To have the best image quality on your monitor, make sure (1) the selected output resolution is
supported by your monitor, and (2) the output settings on both the LCD monitor and the recorder
are consistent.
If the image is not positioned or scaled properly, please go to your monitor's menu for
adjustment. For details, please refer to the user manual of your monitor.
DAYLIGHT
1ST MON AUG
LAST MON OCT
DISPLAY
ON
ON
30
RE,MAINING SIZE
AUTO
ENGLISH
SETUP
SETUP
ON
06:00
10:00
01:00
MAIN MENU
42