Hardware Overview; Front Panel - Avtech 36CH XVR Series User Manual

1. HARDWARE OVERVIEW

1.1 Front Panel

Note: The functions on the front panel and rear panel may vary, depending on the mode you have.
1) Select & Unlock
These two buttons are used to unmount a hard disk. Press Select and check the HDD indicator (red &
always on) to ensure the hard disk you want to unmount is chosen. Then, choose Unlock to unmount the
hard disk (HDD indicator: red & flashing).
When the hard disk unmount is completed, the indicator will be off, and you're ready to remove the hard disk
from the HDD tray.
2) HDD Indicators
Check the HDD indicator for each installed hard disk to ensure the hard disks work normally.
Note: Some statuses are for selected models only.
Color Status
-- No light
Green Always on
Green Flashing
Red Always on
Red Flashing
3) Status LED indicators
Press to power on the device; press and hold for 3 seconds to power off the device.
Note: Some indicators are for selected models only.
This device is power-supplied.
The device is connected to Internet.
The device is connected to LAN.
An alarm event occurs.
Any of the adapter, power or fan is abnormal.
Video playback is on.
An USB flash drive or USB hard disk is connected.
This device is in the standby mode when it's powered off.
4) Power ( )
Press and hold for 3~5 seconds to put your recorder in the sleep mode, and press to wake up your recorder.
5) USB port ( )
Insert a compatible USB flash drive for video backup or a mouse for function operation.
Note: For the compatible list of USB flash drives, please refer to "APPENDIX 3 COMPATIBLE USB FLASH
DRIVE LIST" at page 58.
Meaning
No hard disk is installed, or the installed hard disk is not detected. Please install a hard disk
or replace the installed hard disk, and try again.
The installed hard disk is detected well.
Data reading / writing.
The hard disk is selected for unmounting.
The device is mounting or unmounting the selected hard disk.
1
HARDWARE OVERVIEW