Operation Using The Infrared Remote Controller; Pan/Tilt And Zoom Operation - Bolin Technology D Series Manual

Operation Using the Infrared Remote Controller

Pan/Tilt and Zoom Operation

Panning and Tilting
1. Press the POWER switch.
The camera will turn on and perform the pan/tilt reset operation automatically.
2. Press the arrow buttons to pan or tilt the camera.
While checking the picture on the screen, press the desired arrow button.
To move the camera in short increments, Tap the button or short press for a
moment.
To move the camera in long increments, press and hold the button.
To move the camera diagonally, press the "←, →" button while holding down
the "↑, ↓" button.
Restore to starting position
Press the HOME button.
If the camera moves in a different direction from the one that you
intended
The camera is preset so that the image output from the camera is rotated
toward the right whenever you press the "←, →" button.
To face the camera toward the opposite direction
You might wish to face the camera towards the opposite direction from that of
the button you pressed, for example, when you change the direction of the
camera while checking the picture on the screen. In such a case, press and
hold the Fn key, then press the 2 (REV) button.
Arrow button Movement of the
To reset the setting
To reset the setting, press and hold the Fn key, then press the 1 (STD) button.
Arrow button Movement of the
Note
The above setting only changes the signal emitted from the infrared remote controller and does not change the
setting of the camera itself. Therefore, repeat the setting for each infrared remote controller if you are using
more than one infrared remote controller.
When the STANDBY lamp is blinking
Setting
camera
While holding
down
Press
Setting
camera
While holding
down
Press
35