Table of Contents
Advertisement
BOTTOM DIP SWITCH SETTINGS
The bottom dip switch is for setting the camera configuration for following items:
1. Camera ID Address for RS-485 PELCO protocol
2. Video output / Video color space
3. RS-232 / RS-422/485 selection
4. RS-232 / RS-422/485 baud rate
5. Video resolutions selection
6. IR remote controller ID
Setting of the BOTTOM DIP Switches
Turn off power to the camera before changing the DIP switch settings.
Power on the camera to have the new Dip Switch setting activated.
Please Note: Camera ID and Video Resolution can be set on either the DIP switches or on the OSD menu. Whichever
setting was changed last will be the setting that is loaded when the camera boots.
Always do a hard power cycle on the camera after changing DIP switch settings to apply the settings. This is done by
removing power, allowing the camera to completely power down, and then reconnecting the power.
The DIP Switch Settings
Bit 1~3:
Camera Address setting for VISCA protocol
Bit 4:
Video Output/Video Color Space
Bit 5:
Reserve
Bit 6:
RS-232/RS-422 (* Set RS232 for controlling via HDBaseT)
Bit 7~8:
RS-232/RS-422 Baud Rate
SW1 Factory default setting is: ON.OFF.OFF.OFF.OFF.OFF.OFF.ON.
19
Advertisement
Table of Contents
