Disassembly - Zepro Z 10 Installation Instructions Manual

Disassembly

12 Disassembly
If the tail lift has to be removed from the vehicle, for example to transfer it to another vehicle, for storage or
for modification, please follow these instructions.
1. Support the platform with a crane or similar equipment that can safely carry the platform's weight (see
weight info).
2. Dismantle the upper pivot of the tilting cylinders from the platform and rest the cylinders on the ground.
3. Run the tilting cylinders to their minimum stroke limit to remove pressure from the circuit.
4. Dismantle the side profiles from the platform. Loosen the grease nipples and lock screws in the platform
pivots. Use the Zepro special tool for the platform pivots. Hammer outside with the sliding weight.
5. Follow the same procedures for the other side.
6. Lift off the platform.
7. Raise the 1st booms to their highest position.
8. Disconnect +12-24 V from the control card.
9. Disconnect all controllers from the control card.
10. Support the support frame from underneath, for example with a car jack.
11. Remove the support frame from the vehicle frame by loosening the bolts and carefully lowering the sup-
port frame to the ground with a car jack.
www.zepro.com
Z 10/15/20
51