Table of Contents
Advertisement
Installation
6.11.1 Adjusting the tilt angle
NOTE.
Do not adjust the cylinders before they are fitted
to the platform. The tilting cylinders are preset
from the factory.
1. Close the platform to the body, see Image 46.
2. Unscrew the locking screws (pos. 1, 2, 3, see Im-
age 47).
3. Turn the nut (pos. 4, see Image 47) to adjust
cylinder length and position on the platform. Use
ZEPRO tool part no. 59693 (60 mm). Always
adjust both cylinders.
4. Unscrew the lock screws (pos. 5, 6, 7, see Image
48). Zepro recommends securing the screws with
Loctite 243 or equivalent.
NOTE.
Must always be adjusted with full hydraulic pres-
sure in the tilting cylinders.
Check the dimension, see. Maximum length
must not exceed 33 mm, see Image 49.
WARNING!
The max. length of both cylinders must be adjust-
ed equally to avoid unwanted bending forces.
www.zepro.com
Image 46. Adjusting the fit to the vehicle body
Image 47. Adjusting cylinder length
Image 48. Screw tight the lock screws
Max 33 mm
Image 49. Maximum length
Z 10/15/20
31
Hide quick links:
Advertisement
Table of Contents
