Zepro Z 10 Installation Instructions Manual page 30

Installation
5. Test the lift by carefully raising it to the vehicle
floor level and tilting it to the vertical position.
Check the position in relation to the rear beam
and side posts of the vehicle. See Image 44.
6. The platform underhang (A), see Image 45, var-
ies according to platform type and this should be
taken into account when fitting the upper seal.
30
Max. 40 mm, Min. 38 mm
Image 44. Check the position in relation
to the rear beam of the vehicle
Vehicle floor
level
Type Steel Flat 40 mm
A (mm) 70
Image 45. The platform underhang (A)
varies depending on platform type.
Z 10/15/20
A
Conical
81 77
www.zepro.com