Table of Contents
Advertisement
Installation
6
Installation
NOTE.
Also consult the vehicle manufacturer's body
instructions and Zepro's Operator's Manual
before installation.
WARNING!
Zepro tail lifts are only approved for installation
with Zepro assembly kits.
6.1
Support frame
1. Measure and mark the midpoint of the rear
member of the vehicle. See Image 12.
2. Bolt or spot-weld the mounting jig to the rear
beam, so that both mid-points are aligned, see
Image 13.
3.
Position the support frame under the vehicle frame.
4. Raise the 1st booms to their highest position.
5. Attach the 1st booms to the eye of the jig, see
Image 14. Use the steel platform's normal piv-
ots.
6. The support frame should be positioned as high
as possible within the specified C dimension.
Adjust the frame to the ideal height under the
chassis. A car jack is useful. The frame must be
positioned parallel with the floor of the vehicle
body and must not be in contact with the vehicle
frame; there must be a few millimetres of play.
If necessary, adjust the angle of the arms by
carefully operating the lift.
7. Install the brackets on the support frame so that
its opening is facing towards the front of the
vehicle, and adjust the position of the frame so
they are in contact with the vehicle frame.
8. Install the U-profile with associated washers and
nuts, but do not tighten them. Screw the nuts
alternately until the U-profile is aligned in contact
with the frame, see Image 15
16
Image 12. Measure and mark the midpoint
of the rear beam of the vehicle
Image 13. Bolt or spot-weld the mounting jig to the
rear member part. no. 51724TL for Z 10/15/20
Image 14. Mounting jig.
Image 15. Install the U-profile with
associated washers and nuts
Z 10/15/20
www.zepro.com
Hide quick links:
Advertisement
Table of Contents
