Table of Contents
Advertisement
Installation
When installing on chassis with pre-drilled holes, go
directly to point 16.
9. Install the U-profile with associated washers and
nuts, but do not tighten these. Screw the bolts al-
ternately until the U-profile is aligned in contact with
the frame, see "Image 15. Install the U-profile with
associated washers and nuts" on page 16.
10. When installing on a frame without pre-drilled holes,
install first with a screw in the brackets' slot-shaped
holes. On the mark the middle of the brackets' slot-
shaped holes and then drill Ø14 mm. holes in the
frame; see "Image 17. Install the frame bracket with
at least 6x M14x45 10.9 bolts" on page 17
11. Bolt the brackets securely on the outside of the
vehicle chassis. Use M14x45 bolts and install the as-
sociated washer and nut on the inside of the vehicle
chassis. Install the bolts but do not tighten.
12. Check and perform fine adjustment regarding the
position of the lift. Then tighten the bolts with a
torque wrench.
Tightening torque: 120 Nm.
13. Using a torque wrench, tighten the bolts holding the
U-profiles. Tightening torque: 280 Nm.
14. Drill holes in the vehicle chassis for mounting bolts,
Ø14 mm. Drill in the outer holes of each bracket.
Use M14x45 bolts and install the associated
washer and nut on the inside of the vehicle chas-
sis. Installation must be performed with at least 6
bolts in the outer holes. The bolt that was installed
initially in the slot-shaped hole may not be included
in this figure. If necessary, this bolt can now be
moved to one of the outer holes, see illustration.
Then tighten the bolts with a torque wrench.
Tightening torque: 120 Nm.
15. Remove the mounting jig.
NOTE.
Note that the frame bracket needs a free space of
at least 35 mm between the vehicle frame and the
support frame, see Image 16.
www.zepro.com
35 mm
Image 16. Note that the frame bracket needs
a free space of at least 35 mm between
the vehicle frame and the support frame
D
Min. 20
Min. 260
Min. 6 pcs.
M14x45 10.9
120 Nm
Image 17. Install the frame bracket
with at least 6x M14x45 10.9 bolts
Z 10/15/20
New hole
17
Hide quick links:
Advertisement
Table of Contents
