VAT 612 Series Installation, Operating, & Maintenance Instructions page 78

5. Remove the panel
6. Remove the master board or replace it, if existing
master board is defect
7. Remove the interface board or replace it, if
existing interface board is defect
8. Remove the option board or replace it, if existing
option board is defect
9. Insert all boards in reverse order as they
disassembled at correct positions (see steps
8...6)
10. Reassemble the controller panel
(see steps 5...3).
11. Tighten female screw locks from POWER and
SENSOR connectors with 1.1 Nm
(see step 2)
12. Tighten panel screws with 1.1 Nm
(see step 1)
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
Installation, Operating & Maintenance Instructions
Series 612 DN 63-250 (I.D. 2.5" - 10"), CC-Link
Description Required tool
Open end wrench 10mm
Open end wrench 4.5 mm
Pozidriv screw driver
size 1
289856EA
78/85
2011-07-06