VAT 612 Series Installation, Operating, & Maintenance Instructions page 25

2.6.6.4 Install CC-Link cable at valve controller
3. Remove the cable coat carefully
Cable Pos. A, x about 30mm
Cable Pos. B, x about 40mm
Note: Pos. see step 8
4. Cut off the shield wire
5. Cut off the aluminum shield and remove it
6. Cut off the plastic and remove it
Note:
Take care to the wires. Do not damage the
isolation of wires!
7. Cut off the shield wires about 15mm
8. Separate the shield wires in two equal
quantum and place them 180° opposite
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
Installation, Operating & Maintenance Instructions
Series 612 DN 63-250 (I.D. 2.5" - 10"), CC-Link
Description
x
15mm
Required tool
Knife
Side-cutting pliers
Side-cutting pliers
Side-cutting pliers
Side-cutting pliers
289856EA
25/85
2011-07-06