Power Contacts/Field Supply; Fig 3: Power Jumper Contacts; Table 5: Power Jumper Contacts - WAGO -I/O-SYSTEM 750 Manual

18 Device Description
Po s: 28 /Serie 750 (WAGO-I/O-SYSTEM)/Gerätebeschreibung/Anschlüsse/Leistungskontakte/Feldversorgung - Überschrift 3 @ 6\mod_1256294692864_21.doc @ 43664 @ 3 @ 1
3.2.2

Power Contacts/Field Supply

Po s: 29.1 /Serie 750 (WAGO-I/O-SYSTEM)/Wichtige Erläuterungen/Sicherheitshinweise/Vorsicht/Vorsicht: Verletzungsgefahr durch scharfkantige Messerkontakte! @ 6\mod_1256193279401_21.doc @ 43414 @ @ 1
Risk of injury due to sharp-edged male contacts!
The male contacts are sharp-edged. Handle the module carefully to prevent injury.
Po s: 29.2 /Serie 750 (WAGO-I/O-SYSTEM)/Gerätebeschreibung/Anschlüsse/Leistungskontakte 3 LK (Messer/Feder) @ 7\mod _1266318232808_21.doc @ 50691 @ @ 1
The I/O module 750-502 has 3 self-cleaning power jumper contacts that supply
and transmit power for the field side. The contacts on the left side of the I/O
module are designed as male contacts and the contacts on the right side as spring
contacts.

Table 5: Power jumper contacts

1
1
1
Fig 3: Power jumper
contacts
Po s: 29.3 /Serie 750 (WAGO-I/O-SYSTEM)/Wichtige Erläuterungen/Sicherheitshinweise/Achtung/Achtung: Maximaler Strom Leistungskontakte 10 A @ 3\mod_1226499143500_21.doc @ 25029 @ @ 1
Do not exceed maximum current via power contacts!
The maximum current to flow through the power contacts is 10 A.
Greater currents can damage the power contacts.
When configuring the system, ensure that this current is not exceeded. If
exceeded, an additional potential feed module must be used.
Po s: 30 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Connection
2
1
2
2
2 Spring contact
Type Number
Blade contact 3
3
WAGO-I/O-SYSTEM 750
750-502 2DO 24V DC 2.0A
Function
Infeed of the field
supply voltage
(U , 0 V and earth)
V
Forwarding of the
field supply voltage
(U , 0 V and earth)
V
Manual
Version 1.2.0