Inserting And Removing Devices; Inserting I/O Module; Figure 7: Insert I/O Module - WAGO -I/O-SYSTEM 750 Manual

26 Assembly
Po s: 65.7 /Serie 750 (WAGO-I/O-SYSTEM)/Montieren/Geräte einfügen und entfernen - Überschrift 2 @ 3\mod_1231768483250_21.doc @ 25950 @ 2 @ 1
4.2

Inserting and Removing Devices

Po s: 65.8 /Serie 750 (WAGO-I/O-SYSTEM)/Wichtige Erläuterungen/Sicherheitshinweise/Gefahr/Gefahr: Vorsicht bei der Unterbrechung von FE! @ 6\mod_1256193919214_21.doc @ 43423 @ @ 1
Use caution when interrupting the PE!
Make sure that people or equipment are not placed at risk when removing an I/O
module and the associated PE interruption. To prevent interruptions, provide ring
feeding of the ground conductor, see section "Grounding/Ground Conductor" in
manual "System Description WAGO-I/O-SYSTEM 750".
Po s: 65.9 /Alle Serien (Allgemeine Module)/Wichtige Erläuterungen/Sicherheitshinweise/Achtung/Achtung: Arbeiten an Geräten nur spannungsfrei durchführen! @ 6\mod_1256193963573_21.doc @ 43426 @ @ 1
Perform work on devices only if the system is de-energized!
Working on devices when the system is energized can damage the devices.
Therefore, turn off the power supply before working on the devices.
Po s: 65.10 /Serie 750 (WAGO-I/O-SYSTEM)/Montieren/Busklemme einfügen @ 3\mod_1231769726703_21.doc @ 25989 @ 3 @ 1
4.2.1

Inserting I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 7: Insert I/O module

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.
WAGO-I/O-SYSTEM 750
750-502 2DO 24V DC 2.0A
Manual
Version 1.2.0