Connect Devices; Connecting A Conductor To The Cage Clamp; Figure 10: Connecting A Conductor To A Cage Clamp - WAGO -I/O-SYSTEM 750 Manual

28

Connect Devices

Po s: 67 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Geräte anschließen - Überschrift 1 @ 3\mod_1234172889468_21.doc @ 27460 @ 1 @ 1
5 Connect Devices
Po s: 68 /Serie 750 (WAGO-I/O-SYSTEM)/Anschließen/Leiter an CAGE CLAMP anschließen - Überschrift 2 und Text @ 3\mod_1225448660171_21.doc @ 24928 @ 2 @ 1
5.1

Connecting a conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length
Nominal cross section
WAGO Product
1. To open the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. To close the CAGE CLAMP
then clamped firmly in place.

Figure 10: Connecting a conductor to a CAGE CLAMP

Po s: 69 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
®
connection is appropriate for solid, stranded and
8 mm
2
1 mm for 2 conductors with 0.5 mm
max.
216-103 or products with comparable properties.
®
insert the actuating tool into the opening
®
simply remove the tool - the conductor is
WAGO-I/O-SYSTEM 750
750-502 2DO 24V DC 2.0A
®
connection!
®
connection.
®
®
2
each
Manual
Version 1.2.0