Removing M6 Protection - Marport M6 Mx Service Manual

Removing M6 Protection

From version 06.00.05 and later of Mx receivers, you need to upload a license file into your system
to make it fully operational.
Before you begin
For this task, you need two license files (*.zob). Refer to sales' headquarters to get them.
About this task
Note: This procedure applies for receivers version 06.00.05 and above.
By default, Mx systems are limited to a specific number of sensors: 12 PRP sensors (e.g. catch,
spread, trawl speed...) and 1 NBTE sensor (Explorer sensors). You need a license file to disable this
limitation and to be able to add more sensors. The license file also allows you to add a TE SC sensor
to the system.
Procedure
1. In Firefox web browser (version from 22 to 51), enter your receiver IP address to access the
receiver web page.
On the receiver page, you can see that the system is on the default (DEF) limited configuration
(12 PRP sensors and 1 NBTE sensor).
2. From the tree view of the system on the left side of the page, click Settings.
3. In ZOB Upgrade, click Browse and select one of the two license files.
The system reboots.
4. After the system has rebooted, refresh the receiver page.
5. Open again the setting page and from ZOB Upgrade, add the second license file.
The M6 system reboots again. Restart the Mx computer.
Results
The message on the top of the page indicates the number of PRP (100) and NBTE (10) sensors that
can be added to the system and if a TE SC sensor can be added.
M6 - Mx computer System | V2 | Installation
| 43